Microsonic LCA-2 Manual do Utilizador descarregar pdf (Página 47)

Visualisation of measurements Page 47 of 51

MARKINGS

Blindzone, foreground suppression, switching- and hysteresis points (on sensors with switching output)

and window margins (on sensors with analogue output)

If time markings is active, all X measurements a vertical white line displayed in the diagram. It represents

the time between the measurements

TRIGGER

In the mode Free Run the measuring values are displayed in an continuous way

In the mode Triggered writing starts, when the distance value exceed a trigger level. The presentation

ends with reaching the right window margin and starts only then, when the above mentioned condition

comes true.

In the mode Single Shot displaying starts, when the values exceed a trigger level. The presentation ends

with reaching the right window margin and starts only then, when you click the button Reset.

ZOOM

The displayed measuring range (0 mm to the selected detection range) can be reduced for better

visualisation.

Select a sector with the mouse cursor (hold the left mouse button and drag). The range will be shown and

after you release the mouse button, the window will be zoomed.

To switch off the zoom, click on the graphic and following message will be displayed.

1 2 ... 42 43 44 45 46 47 48 49 50 51

Sem comentários

Microsonic LCA-2 Manual do Utilizador Página 47